Impex, systems for livestock

Nederlands Deutsch Español

Welcome | The company | Agenda | Address | Contact

Rearing nipples

As a good start is very important for rearing, all rearing nipples have an easy to activate 360° side-action pin. The following table indicates the number of birds per specific nipple. The exact number of birds can vary due to local climate conditions and/or regulations.

Nipple no.

Rearing per nipple

Drip cup

10012, 10014-HP,

10015, 10016, 10017-HF,

10023-MP, 10024-MP

15 - 16

YES

10017-LF

12 - 15

Below are the nipples with specifications for rearing. The nipple choice is also dependant on the house system and climate conditions.

10012

Impex SA poultry nipple drinker with red delrin outer body. Stainless steel inside with s/s seating, 10 mm Ø. 360° side-action pin. Assembly by screwing nipple into PVC square tubing (1/8"thread).

Downloads

Water flow 10012

10014-HP

Impex HP poultry nipple drinker. High-quality stainless steel with s/s seating, 10 mm Ø. 360° side-action pin. Assembly by screwing nipple into PVC square tubing (1/8"thread).

Downloads

Water flow 10014-HP

10015

Impex SA poultry nipple drinker. High-quality stainless steel with s/s seating, 10 mm Ø. 360° side-action pin. Assembly by screwing nipple into PVC square tubing (1/8" thread). Also available: Nipple 10015-50 with a lower water flow and nipple 10015-100 with a higher water flow.

Downloads

Water flow 10015
Waterflow 10015-50
Water flow 10015-100

10016

Impex SA poultry nipple drinker. Identical to no. 10015, however, assembly by pressing the nipple with mounting rubber (10016-1) into square or round tubing. Tubing hole should be 11.5 mm.

Downloads

Water flow 10016

10017-LF

Impex SA poultry nipple drinker. Stainless steel, with fixed upper cone and 360º side action pin.

Downloads

Water flow 10017-LF

10017-HF

Impex SA poultry nipple drinker. Stainless steel, with fixed upper cone and 360º side action pin.

Downloads

Water flow 10017-HF

10023-MP

Poultry nipple drinker MP. Indentical to no. 10024-MP, however, assembly by pressing the nipple with mounting rubber (10016-1) into square or round tubing. Tubing hole should be 11.5 mm.

Downloads

Water flow 10023-MP

10024-MP

MP poultry nipple drinker with red delrin outer body. Stainless steel inside with s/s seating plus a thick pin and new top dolley for controlled water flow.

Downloads

Water flow 10024-MP

Previous: Broiler nipples

Next: Layer nipples